Setting Manually - Sony VGF-CP1 Operating Instructions Manual

11
If the connection name is unnecessary to change, press  on the remote
control to proceed to the next step.
The confirmation screen for settings appears.

Hint
Normally it is unnecessary to change the connection name.
12
Confirm the setting, and press  on the remote control to proceed to the next
step.
13
Select [Yes] by pressing   on the remote control, and press
Connection to the access point is confirmed. When connected properly, "Network connection
completed" is displayed.

Setting Manually

If the access point device does not support AOSS, or AOSS does not work properly, set manually by the
following steps.
1
Confirm the access point information.
Confirm the following information. For details on the access point device (wireless LAN router), see the
operating instructions supplied with the access point device, or consult the access point provider.
SSID

Identification for the access point.
Security type

Security type depends on the access point. With this unit, [None], [WEP], [WPA-PSK (TKIP)], [WPA-
PSK (AES)] can be selected.
Encryption key

WEP key or WPA key is required depending on the selected security type.
2
Display the screen below by following steps 1 to  in "Setting with AOSS" (page
1).

(ENTER).