Advertisement
10 • ENGLISH
4. Service
a. Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
5. Electrical safety
Your tool is double insulated; therefore no earth
wire is required. Always check that the main voltage
corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must
be replaced by the manufacturer, authorized
BLACK+DECKER Service Center or an equally
qualified person in order to avoid damage or injury.
If the power cord is replaced by an equally qualified
person, but not authorized by BLACK+DECKER,
the warranty will not be valid.
Warning! Always switch off the mains disconnecting
switch when leaving the machine unattended.
6. Labels on tool
The label on your tool may include the following symbols:
Read
instructions
manual
Poisoning
hazard
Injury
hazard
V ........
...... Class II
Construction
A ........
....
Safety Alert
Hz .......
Symbol
Danger sign, warns users not to direct the water jet at people,
animals, elec- trical equipment or the product itself.
Not connect to potable water.
Warning! Safety signs. Comply with the instructions
provided by the safety signs ted to the appliance. Check
that they are present and legible; otherwise, replacements
in the original positions.
TECHNICAL INFORMATION
INTENDED USE
This appliance has been designed for individual use for
the cleaning of vehicles, machines, boats, masonry, etc, to
remove stubborn dirt using clean water and biodegradable
chemical detergents.
Vehicle engines may be washed only if the dirty water is
Danger of
Explosion
being beaten
hazard
by objects that
Electric shock
bounce
and short
Use eye
circuit hazard
protection
Short circuit
hazard
Wear proper
clothing
Volts
W ........
Watts
Amperes
min .....
minutes
Hertz
.....
Alternating
Current
disposed of as per regulations in force.
f Intake water temperature: See data plate on
the appliance.
f Intake water pressure: Below 10 bar.
f Operating ambient temperature: Above 0 °C.
The machine complies with the IEC.
OPERATOR
The symbol on the front cover identifies the appliance's
intended operator (professional or non-professional).
MAIN COMPONENTS (Fig. A)
The machine is delivered partially disassembled
in a carton.
1. Lance
2. Gun with safety catch
3. High pressure hose
4. Nozzle
5. Rotating nozzle
6. Adapter
7. Water filter
8. Brackets
9. Detergent kit
10. Nozzle cleaning tool
11. Screws
12. Electric cable with plug
13. Handle
14. Wheels
15. Lever
16. Hose reel
Caution! Safety devices:
f Starter device (21): The starter device prevents
accidental use of the appliance.
Do not tamper with or adjust the safety valve setting.
f Safety valve and/or pressure limiting valve:
The safety valve is also a pressure limiting valve.
When the gun trigger is released, the valve opens
and the water recirculates through the pump inlet or is
discharged onto the ground.
f Thermostat valve (where fitted):
If the water temperature exceeds the temperature
set by the manufacturer, the thermostat valve
discharges the hot water and draws in an amount of
cold water equal to the amount of water discharged,
until the correct temperature is restored.
f Safety catch (20): Prevents accidental spraying of water
f Overload cutout: stops the appliance in case of overload.
INSTALLATION (Fig. B)
ASSEMBLY
Caution! All installation and assembly operations must
be performed with the appliance disconnected from the
mains power supply.
Advertisement
