Replacing The Collimator Lamp - Siemens MOBILETT Plus Service Instructions Manual

Replacement and repairs on the collimator
A
A
Fig. 1
Fig. 3

Replacing the collimator lamp

Equipment required: Lux meter
•
Remove the cover (1) by removing the screws (4) marked "A" (Fig. 1). Turn the collimator
around so that the lamp housing is in front of the cover opening.
•
Remove the protective plate (2), covering the collimator lamp by loosening, not
removing, the screws marked "B" one turn. Do not adjust screws "C", "D", or "E" (Fig. 2).
•
Remove the defective lamp and replace it with a new lamp (Fig. 3). Do not touch the
bulb with bare fingers. (See "list of spare parts".)
•
Reinstall the protective plate. Tighten the screws marked "B".
Siemens-Elema AB
Solna, Sweden
A
1
A
MOB00474
SPR8-215.898.01
Rev. 05
2
B
D
Fig. 2
Page 1 of 8
01.02 SPS-UD
9 - 1
9
B
E
C
MOBILETT Plus / - E/ - M
9