Table of Contents
Advertisement
6
SÓLO ENTRENAMIENTO
ÓLO ENTRENAMIENTO
SOLO PER ADDESTRAMENTO
POUR LA FORMATION UNIQUEMENT
CHANGING THE CONFIGURATION
The AED Trainer 3 is shipped with a configuration replicating the default
factory settings of the FR3 AED. If you want to change the AED Trainer 3
configuration to match local protocols or for other training purposes, follow
the steps below:
1.
Squeeze the latch on the battery compartment lid to release the lid. Lift
out the lid and set it aside.
2.
Remove the Operating System Card from the slot at the top of the
compartment.
3.
Insert the Operating System Card into the card slot of your computer or,
if no slot is available, install the card into a standard card reader and
connect it to your computer.
4.
Open the AED Trainer 3 Configuration program (Aedt3Cfg.exe) and
select the desired language for use during configuration.
5.
Click "Open," and go to the drive with Operating System Card.
6.
Click on "System" and then on "Config" and then open the "Config.Dat"
file to load the existing Trainer 3 setup to the program.
7.
Adjust the parameter settings as desired. See page 15 for detailed
information about the available settings.
Advertisement
Table of Contents
