Chapter 10. Error List; Error List - Sharp AX-1100 Service Manual

AX1100(R)
AX1100(R)
CHAPTER 10.

ERROR LIST

[1] Error List
Error EE
Detail of error
display code
Oven temperature
Err 04
is high.
Err 0F Water tank is frozen
Err - Time input error
Err 0A Shortage of Water
Error EE Detail of error
display code
Grill thermistor
11
error SHORT
EE01
Grill thermistor
12
error OPEN
EE05 15 Engine heater error
Intake Damper
18
error
01 Antenna error
Engine thermistor
EE12 1C
error OPEN
FLASH error
EE14 1E (FLASH data verifi-
cation error)
Something is burn-
RESET - ing in the oven by
MICRO heating.
How to operate test mode
(Power on and door closed)STOPSTEAM HIGHMICRODoor openSelect Test No. 2 by [WEIGHT UP/ DOWN]STARTSelect Address
04h (or 05h)START
EE code: EE code is memorized in the FLASH address 04h as error history. (Only antenna error code is memorized in the FLASH address 05h.)
NOTE: When an error mode occurs except for shortage of water error and the oven stopping state continues for more than 3 minutes, the oven will
be powered off by Energy save mode function.
Application
Error condition
Defrost
Oven temperature is too
Steam Low
high
(under 85C)
Engine heater tempera-
Engine menu
ture is too low.
More than maximum Manual steam
cooking time is input menu
Water in the water tank
isn't enough. Engine menu
Tube pump assembly or except Defrost
pump motor is out of menu
order.
Error condition
Grill thermistor is short.
Grill thermistor is open.
Engine heater temperature is
too high.
Damper or Damper switch doesn't work.
Damper is stopped if on and off at damper switch port is
not detected within 1 min.
When Damper error is detected, the cooking is stopped.
Antenna or antenna switch doesn't work.
When antenna error is detected, output of microwave is
stopped.
Engine thermistor is open.
FLASH Read data is not
same as FLASH write data.
Rapid changes in oven ther-
mistor level.
10 – 1
Service Manual
Check method
menu
Grill thermistor
Grill thermistor
Key input
Engine thermistor
Grill thermistor
Application menu Check timing
Immediately from
Oven mode
heating start
Always from heating
Fermentation mode
start
Always from heating
Engine menu
start
Every mode that
damper works.
Microwave mode
Always operate
Engine menu more than 30sec.
under 5 bit.
PWB short check pro- Short check pro-
gram gram
All cooking mode or
stop state, check oven
After 5min.
thermistor level continu-
ously.
Check timing Note
"HOT" is blinking
Immediately
in the display.
Always
Steam High/Low
key is pressed.
The cooking is
After engine heater
stopped.
was from on to off
Only stop/clear
once.
key is available.
Note
Error isn't displayed.
EE code is memorized
in the FLASH address
04h, if other error has
not occurred.
Error isn't displayed.
EE code is memorized
in the FLASH address
05h.
When the error
detected, power is cut
off.