Chapter 11. Test Mode - Sharp AX-1100 Service Manual

test name
No
(1) Push "START". PM starts.
10 TOTAL TEST
direct select key: [info]
After 30 sec.
how to operate at production
line
power on
[STOP/CLEAR]
After 1min. judgment
[info]
[MICRO]
(2) steam mode
Steam mode (high) works for 30 min.
[MICRO]
[START]
[info]
(3) Judgment
(4) Shortcut to the test mode 06
When OK display (1111) and "CHECK" display appears, test mode 06 starts
by pushing [START] key.
Before pushing [START] key, water tank should be removed. (Refer to test mode 06)
You don't have open the door.
The detail of judgment (test no. 10)
Display Error timing
01 During microwave mode
0 11 After 18 sec from start
- -0 Right after starting
00 00 During steam heating mode
00 00 During steam heating mode
00 10 During microwave mode
00 10 During microwave mode
11 11
detail of test
" 01" appears when Antenna is defect.
And test mode doesn't continue.
Test mode doesn't continue.
*Check the engine thermistor works correctly. (open / short check)
*"CHECK" display appears after FLASH (2) min.
OK ETH is OK.
NG see next page
ETH OTH
Not judged Not judged
Not judged Not judged
Not judged Not judged
NG Not judged
NG Not judged
Not judged NG
Not judged NG
OK OK
RY-1, FM, PM
I. DAMPER: OPEN
MICRO (0%)
MICRO (100%)
FM, COOK (OL)
PM
I. DAMPER: OPEN
RY-1, EH, PM, FM
I. DAMPER: CLOSE
Antenna Damper
NG Not judged Antenna ERROR
Not judged NG Damper ERROR
Not judged NG Damper ERROR
OK OK Engine thermistor is defect (short).
OK OK Engine thermistor is defect (open) or Engine heating element does
not work when error appears after 30 sec.
OK OK Oven thermistor is defect (short)
OK OK Oven thermistor is defect (open)
OK OK
output example of display
Judgment
OK