Toshiba RUAGP Series Original Owner's Manual page 28

System information screen
• Use the and
• Use the and
information item.
Refer to the table below for the items and content of display
information.
Item Unit
System ─
UC No. units
Mode ─
Run ─
Failure ─
Flw ctrl ─
PST °C
EWT °C
LWT °C
LRWT °C
LSWT °C
OAT °C
RHT %
Load flw L/min
Unit flw L/min
Ope Capa %
Capacity kW
Diff kPa
Vlv opn %
Demand A/kW/%
GC ─
* The standards that can be set during demand control are
"Current (A)", "Operation Capacity (%)", "Rated power ratio
(%)", "Power consumption ratio (%)", and "Power (kW)".
- 26 -
buttons to switch the displayed system.
buttons to switch the displayed
Description
Displays "MC-A" or "MC-B"
Indicates the number of UCs connected to the
system
"Cooling", "Heating" or "Stopped"
Displays "Run", "Stopped" or "Disabled"
Failure code is displayed: Failure state
Blank: Normal state
Step (stepped variable flow rate)
Byps0 (bypass flow zero control)
Displays the setting outlet water temperature
Displays the average inlet water temperature of
each heat pump
Indicates the average outlet water temperature of
each heat pump
Indicates the return water temperature (external
input)
Indicates the supply water temperature (external
input)
Indicates the average outdoor air temperature of
each heat pump
Indicates relative humidity (only for HEATEDGE)
For other than HEATEDGE, "---" is displayed
Indicates the flow rate on the load side from the
bypass (external input)
Indicates the total flow rate (external input) of
each heat pump
Indicates the average operating capacity of each
heat pump
Indicates the total capacity of each heat pump
Indicates the supply and return water differential
pressure (external input)
Indicates the motorized valve opening instruction
(external output) installed on the bypass pipe
between the supply and return water
Displays the demand setting value when demand
control is enabled (*)
OFF: Demand control disabled
Displays GC "System 1 to 16" for remote except
for Modbus control