Epson ICDmini 3.0 User Manual page 14

A display example using Explorer is shown below. In this example, E drive is allocated to the ICDmini Ver.
3.0 as a storage.
Figure 5.3 Example of Drive Allocation to ICDmini Ver. 3.0 (Storage)
(5) Disconnecting the ICDmini Ver. 3.0
After the firmware has been updated, remove the ICDmini Ver. 3.0 device from the host computer by
clicking the Safely Remove Hardware icon in the notification area, at the right of the taskbar, and select
"Eject LPC1XXX IFLASH" in the list of devices that appears. Then unplug the ICDmini Ver. 3.0 from the
host computer.
(6) Resetting the jumper switch and attaching the bottom cover
Remove the jumper pin set in Step (2) and put it back into the original position. Then attach the bottom
cover paying attention to the direction (align the side of the cover with the notch to the 10-pin connector
side).
ICDmini Ver. 3.0 User Manual
(Rev. 1.0)
Figure 5.4 Removing ICDmini Ver. 3.0 (Storage)
Seiko Epson Corporation
5. Firmware Update
11