Bosch Rexroth lndraControl VPB 40.1 Project Planning Manual page 57

DOK-SUPPL*-VPB*40.1***-PR02-EN-P
Rexroth IndraControl VPB 40.1 Control Cabinet PC
ISA/PCI slot A3
PCI slot A2
Fig.8-10: Position of the slots for extension cards
9. Then, snap in the cover again.
10. Mount the housing cover.
11. Plug in the battery cable again.
WARNING
The combined PCI/ISA bus slot must not be equipped with a PCI card and an
ISA card at the same time!
If the card is equipped with a Plug and Play (PnP) function, it is automatically
recognized by the operating system and integrated in the system, provided that
there are no hardware conflicts (IRQ etc.) with other extension cards or con‐
nected devices.
There can be different causes if functions - based on the new card - are not
available after the system reboot:
● The card is not properly seated in the PCI or ISA slot.
● The driver software of the card is not installed or its installation is faulty.
● IRQ (Interrupt) conflict with other PC hardware components.
● The software of the card was not installed.
WARNING
Consider the specifications of the card manufacturer. It might be required to set
new configurations in the BIOS and in the operating system (e.g. Windows
Control Panel).
Bosch Rexroth AG
Maintenance and Installation
Extension board for 3 cards
PCI slot A1
Connector cover
Cover
Destruction of an extension card or of the main
board caused by parallel equipment with PCI
and ISA card!
Risk of destruction of the main board or the ISA
card caused by address conflicts (IRQ, mem‐
ory access, I/O address)!
55/81