Wiring The Front Connector Module - Siemens S7-1500 Manual

Connecting
4.3 Connecting components
7. Latch the cable grip
8. Repeat steps 3 – 5 to connect the round-sheath cable connector to the "lower connector,
4.3.2

Wiring the front connector module

Introduction
This section explains how to wire the front connector modules.
Note
Please also read Wiring SIMATIC TOP connect to the I/O modules (Page 33) for special
connection examples and the criteria for selecting front connector modules.
Functions of the front connector module
The front connector module is used to connect the connecting cable to the I/O module. The
supply voltage cables for the modules can also be connected to the front connector module.
See also
Wiring SIMATIC TOP connect to the I/O modules (Page 33)
26
③
Figure 4-3 Fitting the strain relief
front connector module" and the "upper connector, front connector module" connection
ends.
on the connector into place.
SIMATIC TOP connect for S7-1500 and ET200MP
Manual,