Siemens SIMATIC IPC277D/E 19" INOX PRO Service Manual page 20

Extended maintenance work
4.5 Changing the mounting type
5. Reposition the LVDS display cable, the touch cable and the BLI cable from the rear panel
to the front as shown in the figure below.
6. Only for devices with operator controls: Connect the plug of the flat ribbon cable with the
rear panel electronic. Make sure that you do not reverse the polarity. Secure the flat
ribbon cable with a new piece of adhesive tape (X).
7. Connect the plugs of the LVDS display cable, the touch cable and the BLI cable with the
corresponding interface of the front electronic. Secure the touch cable and the BLI cable
with the adhesive tapes that you saved when you removed the cables as shown in the
figure below.
20
SIMATIC IPC277D/E 19" INOX PRO, SIMATIC IFP1900 INOX PRO
Service Manual, 11/2017, A5E35751762-AC