Table of Contents
Advertisement
Extended maintenance work
4.6 Fastening the rear panel
Tool required
Allen wrench, size 8 mm
Procedure
1. Make sure that the seal is flush with the rear panel and does not protrude between rear
panel and front.
2. Screw in the four screws in the corners of the rear panel about halfway as shown in the
figure below.
3. If necessary, correct the position of the rear panel.
4. Screw in all 20 screws of the rear panel completely.
5. Tighten the screws with a torque of 3.5 Nm.
22
SIMATIC IPC277D/E 19" INOX PRO, SIMATIC IFP1900 INOX PRO
Service Manual, 11/2017, A5E35751762-AC
Advertisement
Table of Contents
