Epson Stylus Pro 4000 Printer Manual page 106

106 | Maintaining and Transporting the Printer
Follow these steps to use the maintenance mode:
1. Make sure the printer is turned off. Press and hold the
then press the P Power button until the printer turns on and displays
on the LCD panel.
HEX DUMP
2. Press the or
need to back up to the previous menu level, press the the
To print a hex dump of data in the printer's buffer, press the
•
button to display
Menu
to print the 16-byte hex data in the left column and corresponding
ASCII characters in the right column. Press the
print the last page.
To change the language displayed on the LCD panel, press the
•
button until you see
Press the button until you see the language you want, then press
again to select it. The printer exits maintenance mode
Menu
and returns to normal operation.
To change the units of measurement, press the
•
see , then press the
UNIT
switch from
METER
the units you want. Press the the
To change the default cutting pressure, press the
•
see
CUT PRESSURE
. Press the
100%
to increase it (in 1% increments). Press
setting you want.
To run a super strong cleaning cycle, press the
•
see , then press the
SSCL
to start the cleaning cycle.
Menu
To return all control panel settings to their default values, press the
•
the button until you see
button to display
Menu
the default settings.
3. To exit the maintenance mode, turn off the printer by pressing the
P Power button. Press the P Power button again to turn on the printer
in the normal operating mode.
4-106
button to select the settings described below. If you
. Then press
EXEC
, then press the
LANGUAGE
Menu
to
FEET/INCH
, then press the
button to decrease the presure, or the
Menu
DEFAULT PANEL
EXEC.
Pause button,
button.
Menu
Pause button to
Menu
button until you
button. Press the button to
, then press
Menu
button when done.
button until you
button to display
Menu
to select the
Menu
button until you
button to display
EXEC
, then press the
Press again to restore
Menu
again
button.
to select
button
. Press