Documents You Sent Are Received Blank; One-Touch Or Speed Dial Faxing Does Not Work; Receiving; Manual Reception Doesn't Work - Epson PriorityFax 3000 Owner's Manual

Sending
(continued)

Receiving

Documents you sent are received blank.

• Be sure you sent the document through the fax machine face
down. Resend the document, being careful to place the
document in the feeder face down.
One-touch or speed dial
You may have used a one-touch or speed dial number that is a
•
telephone number, not a fax number. Check to be sure the
number you are dialing is a fax number, and try again.
You may have pushed a one-touch or speed dial number that is
•
not registered properly. Check Chapter 2 for proper
registration procedures.
Delayed Sending is set. Turn off Delayed Sending before using
•
one-touch or speed dial faxing.

Manual reception doesn't work.

• A document is in the feeder. Remove the document and try
manual reception again.

Recording paper is jammed.

• Push down on the recording paper cover button to open up
the fax machine. Pull out the jammed recording paper. Use
scissors to make a clean edge on the end of the paper roll.
Reinsert the paper according to the instructions in Chapter 1.

Received copies are blank.

• The recording paper roll may be in upside down. Reinsert
the paper according to the instructions in Chapter 1.
• Documents may have been sent to you incorrectly. Check with
the sending party.
work.
faxing does not
Troubleshooting
5-3