Maintenance; Power Plug/The Back/Floor Of The Refrigerator; Vacuum Compartment - Hitachi R-X670GE Instruction Manual

MAINTENANCE

Warning
■ When dirt is found
● Wipe off it immediately. It is recommended to clean the hidden places once a year.
Power plug
1
Unplug the power cord from the outlet.
If the dust on the power plug remains not
cleaned, it may cause a fire.
2
Check the following matters.
・ Is any damage found on the power cord?
・ Does the power plug become hot?
※ If there is any abnormality, please consult with your dealer about it.
3 Remove the dust and
wipe it with a dry cloth.
4
Connect the power plug
firmly to a power outlet.

Vacuum Compartment

1
Pull out the Vacuum Case.
For how to remove,
Be sure to remove foods contained in the Vacuum Case.
2
Wipe off following parts with a soft cloth
which is steeped in lukewarm water.
※ Do not use the detergents, etc.
Aluminum Tray
Request
● Wipe the ceiling of the compartment (platinum catalyst
and LED light) gently. Failing to do so may cause damage.
● If detergents and others except lukewarm water are used
to clean the vacuum compartment gasket, the vacuum
compartment gasket may be damaged, deformed or change in
color, which may cause the vacuum state unable to keep well.
3
Attach the Vacuum Case.
For how to attach,
Loosened vacuum compartment gasket or loose-fitting door of the
Vacuum Case may cause the vacuum state unable to keep well.
28
● Make sure to unplug the power plug when maintaining the refrigerator.
Once or twice a year
Once a month
Pg.32
Vacuum Compartment
Vacuum Container
Vacuum compartment gasket
Pg.32
The back/floor of the refrigerator
1
Pull the leg cover and
remove it.
Push it in from the front when installing it.
2
Float the Adjustable
mounts from the
floor and draw the
refrigerator straight.
Lay the protection board etc. on
the floor which can be easily scratched.
3
Wipe off dirt on the back of
the refrigerator, duct on the
side, wall and floor.
The back of the refrigerator easily becomes
dirty because fine dust is accumulated on it by convection of air.
When the Vacuum Compartment Gasket is dirt
Remove the vacuum compartment gasket
1
from the Vacuum Case.
Grasp the tab of the vacuum
compartment gasket on the
observer ' s upper right and
remove it by hand carefully.
Gasket seat
Rinse dirty portion in water using a soft sponge, etc.
2
※ Do not use the detergents, etc.
Wipe off excess moisture with a dry
3
cloth and dry it out naturally.
Wipe off dirt in the vacuum
4
compartment gasket
mounting groove.
Attach the vacuum compartment gasket.
5
Align the tab to the notch accurately, and then combine
them together.
Once or twice a year
Groove for attaching the vacuum compartment gasket.
Notch of the groove
Tab
Lift up the
adjustable mount
by turning it
anticlockwise.
Duct on the side
Tab