Waste Ink Pads - Epson Stylus NX100 Service Manual

Epson Stylus NX100/105/SX100/105/TX100/101/102/103/105/106/109/ME 300/ME OFFICE 360/NX110/115/SX110/115/TX110/111/112/113/115/117/119

4.5.14 Waste Ink Pads

Parts/Components need to be removed in advance:
Scanner Stand/Cover Wire(p 68), Scanner Unit
Panel Unit (p 72), Main Board (p
CR Motor/ Driven Pulley (p 83), Ink System
PF Roller (p 98), LD Roller/ ASF Unit
Removal procedure
1. Remove the Waste Ink Pads (A - F) from the Lower Housing.
Lower Housing
Waste Ink Pads (A-F)
A
Figure 4-100. Removing the Waste Ink Pads
DISASSEMBLY/ASSEMBLY
(p 70), Middle Housing
73), EJ Roller/ EJ Frame Assy (p 81)
(p 85), Main Frame (p 92)
(p 99)
E
C
D
B
Disassembling the Printer Mechanism
When installing the Waste Ink Pads, align the ribs of the Lower
Housing with the notches of the Waste Ink Pads. (See Fig.4-100.)
When installing the Diffusion Sheet in the section B, install the
(p 71)
Waste Ink Cover and the Waste Ink Pads (x3) in the order
shown below.
Parts in section B
When installing the Diffusion sheet and the Waste Ink Cover in
the section B, be sure to align their dowels with the positioning
holes of the Lower Housing, then secure them without any gap.
Install the Waste Ink Pads (x2) in the section C in the order
Rib
shown below.
Parts in section C
2
1
Diffusion Sheet Duct Tube End
4
Figure 4-101. Installing the Waste Ink Pads (1)
1
2
Figure 4-102. Installing the Waste Ink Pads (2)
Revision C
3
5
Dowel
Notch
Notch
102
Confidential