Front-Panel Description; Rear Panel Description; Side Panel Description - D-Link des-1228/ME Hardware Installation Manual

DES-1228/ME Metro Ethernet Managed Switch Hardware Installation Guide
F -P D
RONT ANEL
DES-1228/ME Ver. B1:
• Twenty-four 10/100Mbps BASE-T ports
• Two 100/1000 SFP Ports
• Two Combo 10/100/1000BASE-T/SFP ports
• One female RJ-45 console port
• LEDs for Power, Console, Link/Act/Speed for each port
R P D
EAR ANEL ESCRIPTION
The rear panel of the Switch contains an AC power connector. The AC power connector is a standard three-pronged
connector that supports the power cord. Plug-in the female connector of the provided power cord into this socket,
and the male side of the cord into a power outlet. The Switch automatically adjusts its power setting to any supply
voltage in the range of 100 ~ 240 VAC at 50 ~ 60 Hz.
S P D
IDE ANEL ESCRIPTION
The left and right-hand panels of the Switch have heat vents to dissipate heat. Do not block these openings, and
leave at least 6 inches of space at the rear and sides of the Switch for proper ventilation. When choosing a location
for the switch, please keep in mind that without proper heat dissipation and air circulation, system components
might overheat, which could lead to system failure.
Chapter 1 - Introduction
ESCRIPTION
Figure 1- 2. Front Panel of the DES-1228/ME Ver. B1
Figure 1-3. Rear panel view of the DES-1228/ME Ver. B1
Figure 1- 4. Side panels of the DES-1228/ME Ver. B1
Page | 12