Table of Contents
Advertisement
LEDs and recorder status
The relationship between the on/flashing status of the indicator LEDs on the recorder
and camera and the operation status of the recorder is shown in the table below.
: LED lit
LED status
REC
READY BUSY
1
1
"REC LED" refers to the following indicators and pins:
• REC LED on recorder
• REC LED on camera
• GPIO9 (pin 25) output of GPIO/SERIAL port (Rec Tally)
The REC LED on the camera and the GPIO9 output connector will not flash
immediately after power-on.
Shows the following P2 card status information:
2
• No P2 card is inserted.
• P2 card does not have sufficient free space.
• Write-protect switch is set to the PROTECT position on at least one card.
<When using 16 GB or higher P2 cards>
• P2 cards have been inserted into both slots 1 and 2.
• P2 card has not been formatted.
• Maximum number of recording days or files has been exceeded.
• Folders on the P2 card have been modified on a computer or other device.
3
The REC LED normally blinks under the following conditions:
• There is little space left (about 30 minutes or less) on a P2 card.
• You are nearing the maximum number of recording files per day.
4
Carried out by the recorder in response to a request by the Toughbook
Arbitrator Front End Software.
: LED flashing
Immediately after power-on
During startup
Standby (recording possible)
Standby (recording impossible)
Recording in progress
Post-recording in progress
File restoration in progress
Playback (upload) in progress
Setting change in progress
Cover is open
Shutdown in progress
: LED out
Recorder status
3
4
6
(continued on next page)
2
5
23
Advertisement
Table of Contents
