Table of Contents
Advertisement
Notes on handling
• Do not disconnect the power cable
while the recorder is operating. Be
sure to perform recorder shutdown
before disconnecting the cable.
Otherwise recorder setting files
and P2 card managing information
may be lost or damaged.
When the SIGNAL pin at the DC
IN connector goes OFF, the
recorder will perform shutdown
after an interval set with the
Toughbook-Arbitrator Front End
Software.
• Do not open the cover during P2
card access (BUSY LED is lit or
flashing). Do not exert undue force
on the cover to prevent damage.
• Never remove the P2 card from
the card slot during P2 card
access (BUSY LED is lit or
flashing). Otherwise data on the
P2 card will be destroyed.
• Take care not to pinch your fingers
in the P2 card slots or the cover.
• Protect the connector section of
the P2 card from dust, sand,
moisture etc. If a card has been
exposed to any of these, do not
insert it in the P2 card slot.
• Take care that no dust, sand,
moisture etc. can enter a P2 card
slot.
• Before closing the cover, make
sure that the EJECT button is
folded to the right.
• Do not exert undue force on the
EJECT button to prevent damage.
(continued)
Precautions when using
16 GB or higher P2 cards
• Use only one P2 card. If you insert a
16 GB or higher P2 card into slot 1, for
example, do not insert anything into
slot 2.
Be sure to format new cards on a
•
computer that has the P2 card
driver installed.
Formatted P2 cards contain
•
folders necessary for operation on
the Memory Card Video Recorder.
Do not modify (delete, copy,
move, etc.) these folders using a
computer or other device.
If the folders on a card have been
•
modified on a computer or other
device, you must reformat the
card.
If the limit on the number of
•
recording days or files has been
exceeded on a card, the card will
be detected as full even if there is
space left on it.
What to do in case of a problem
• If the recorder or camera was
dropped, or if a foreign substance
has entered a unit, stop recording,
shut down the unit and disconnect
the power cable.
• If a component emits smoke,
unusual smell or noise, or if another
problem occurs, disconnect the
power cable.
Maintenance
• Before performing any maintenance
operation, make sure that the
recorder is not operating and then
disconnect the power cable.
• Regularly check the ventilation
holes for blockage by dust etc.
9
Advertisement
Table of Contents
