Table of Contents
Advertisement
NC1500C
4.3
Configuration
4.3.1
Lamp Setup
Adjust
Adjusts the lamp output (brightness). Control the output at 10W increments.
• Lamp output below 70% will cause an error. Arrange the setting so that the lamp output
Note
becomes 70% at least.
Feedback
Sets the lamp brightness constant mode that uses a brightness sensor.
Disable
Enable
4.3.2
Setup
This menu is for service personnel. For the procedure to use it, refer to "4.1.1. When you
use the service personnel menu" (page D-40).
Douser Mode
The douser function will be activated when signals are switched.
dealer/distributor to perform the setting.
Disable
Enable
D-42
← Displays the lamp output (%) with regard to the setting.
← Adjusts the lamp brightness.
← Displays the currently selected item with asterisk (*).
← Displays the setting.
Disables the lamp brightness constant mode.
Enables the lamp brightness constant mode.
← Displays the currently selected item with asterisk (*).
← Displays the setting
Disables the douser mode.
Enables the douser mode.
4. LCD Menu
Request your
Advertisement
Table of Contents
