Toro Groundsmaster 4100-D Service Manual page 141

Removal (Fig. 78)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake, and remove
key from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. To prevent contamination of hydraulic system during
lift cylinder removal, thoroughly clean exterior of cylin-
der and fittings.
NOTE: To ease reassembly, tag the hydraulic hoses to
show their correct position on the lift cylinder.
4. Disconnect hydraulic hoses from lift cylinder.
5. Remove flange head screw and lock nut that secure
the pin to the lift arm. Remove pin from lift arm and cylin-
der shaft clevis which will free lift cylinder from lift arm.
6. Remove one cotter pin from upper lift pin. Pull upper
lift pin from frame and cylinder barrel clevis.
7. Remove lift cylinder from machine.
Groundsmaster 4100--D
Installation (Fig. 78)
1. Position cylinder barrel clevis to frame and insert up-
per lift pin into frame and clevis. Secure lift pin with cotter
pin.
2. Insert pin through lift arm and cylinder shaft clevis.
Secure pin to lift arm with flange head screw and lock
nut.
3. Attach hydraulic hoses to lift cylinder.
4. Fill reservoir with hydraulic fluid as required (see Op-
erator's Manual).
5. After assembly is completed, operate lift cylinder to
verify that hydraulic hoses and fittings are not contacted
by anything.
Page 4 - - 99 Hydraulic System