D-Link DSL-2750U User Manual page 26

Hide thumbs Also See for DSL-2750U:

Table of Contents

Section 3 – Web Configuration



Adding a PVC in Bridging mode

For PVC in Bridging mode, keep the settings as defaults.

Note:

If the connection protocol is in Bridging mode, the connected PC must

dial for WAN connection with installed dial-up software.

Step 5

After setting (take adding a PPPoE PVC as an example), click Apply

and the page skip to the page shown as the right figure appears. You

can edit or delete the PVCs in the table.

Internet Setup-Ethernet WAN

Choose SETUP > Internet Setup. In this page, select Ethernet in WAN Access

Type. And then the page is shown as the figure appears on the right. In this page,

you can add or configure WAN interface of your router.

Click Add.

Note:

If the selected WAN access type is Ethernet, please connect the

LAN/WAN port to the Ethernet uplink jack through a RJ45 cable.

D-Link DSL-2750U User Manual

Table of Contents