D-Link DSL-2750U User Manual page 38

Section 3 – Web Configuration
Step 6 In Pre-Shared Key textbox, set the password for the wireless network.
WPS Settings
Choose ADVANCED > Advanced Wireless > WPS Settings. This page is used
to configure WPS settings.
There are 3 methods to realize wireless connection through WPS.
- PBC
Click the PBC button in this page. And then click WPS button on the client to be
connected within 2 minutes. The connection will be established.
- Based on the PIN of wireless client to be connected.
1) Select Enabled to enable WPS.
2) In select Mode drop-down list, select Enrollee.
3) In Configuration State drop-down list, select Unconfigured.
4) In Input Station PIN textbox, input the PIN code of the wireless client to
be connected.
5) Click Apply to start wireless connection via WPS.
- Based on the PIN of the DSL-2750U.
1) Select Enabled to enable WPS.
2) In select Mode drop-down list, select Registrar.
3) In Configuration State drop-down list, select Unconfigured.
4) Input the Generate PIN at wireless client to be connected.
5) Click Apply to start wireless connection via WPS.
D-Link DSL-2750U User Manual
36