Toro 41106 Operator's Manual page 20

2
1
Figure 21
1. Agitation control valve
For agitation to work, the pump must be on and the engine
must be running above an idle. If you stop the sprayer and
need agitation on, place the range selector in the Neutral
position, set the parking brake, press the accelerator pedal
to the floor, and turn the neutral engine speed control on.
Pressure Gauge
The pressure gauge is located to the right of the tank
(Fig. 21). This gauge shows the pressure of the fluid in the
system in psi and kPa.
Pump
The pump is located near the front of the tank on the right
side (Fig. 22).
2
Figure 22
1. Pump
2. Pressure gauge
1
2. Grease fitting
20
Tank Drain Knob
The tank drain knob is located on top of the tank (Fig. 23).
Turn the knob counterclockwise to drain the tank.
1
Figure 23
1. Tank drain knob
Tank Cover
The tank cover is located in the center of the top of the tank
(Fig. 24). To open it, turn off the engine, then turn the front
half of the cover to the left and swing it open. You can
remove the strainer inside for cleaning. To seal the tank,
close the cover and rotate the front half toward the right.
2
Figure 24
1. Tank cover
Anti-siphon Fill Receptacle
To the front of the tank cover is a hose receptacle with a
threaded fitting and a 90 degree barbed fitting which you
can direct toward the tank opening (Fig. 24). This
receptacle allows you to connect a water hose to it and fill
the tank with water without contaminating the hose with
the chemicals in the tank.
1
2. Anti-siphon fill receptacle