Toro 41106 Operator's Manual page 25

5. Turn the Spray Pro selection dial to the Application
Rate position and use the application rate switch to
achieve the desired rate.
6. Set the master boom switch to the On position to begin
spraying.
Note: When the tank is nearly empty, the agitation may
cause foaming in the tank. In this case, turn the agitation
control valve to the 3 o'clock position to turn it off.
Alternatively, you can use an anti-foaming agent in the
tank.
7. When finished spraying, set the master boom switch to
the Off position to turn off all booms, then set the pump
switch to the Off position.
Operating Tips
Do not overlap areas that you have previously sprayed.
Watch for plugged nozzles. Replace all worn or
damaged nozzles.
Use the master boom switch to stop the spray flow
before stopping the sprayer. Once stopped, use the
neutral engine speed control to hold the engine speed up
to keep the agitation running.
You will obtain better results if the sprayer is moving
when you turn the booms on.
Watch for changes in the application rate that may
indicate that your speed has changed beyond the range
of the nozzles or there is a problem with the spray
system.
Cleaning the Sprayer
Important You must always empty and clean the
sprayer immediately after each use. Failure to do so may
cause the chemicals to dry or thicken in the lines, clogging
the pump and other components.
1. Stop the sprayer, set the parking brake, place the range
selector in the Neutral position, and turn off the engine.
2. Use the tank drain knob to drain any unused material
from the tank and dispose of it according to local codes
and the material manufacturer's instructions.
3. Fill the tank with at least 50 US gallons (190 L) of clean
fresh water and close the cover.
Note: You can use a cleaning/neutralizing agent in the
water as needed. On the final rinse, use only clean, clear
water.
4. Start the engine.
5. With the range selector in the Neutral position, press the
accelerator pedal to the floor and set the neutral engine
speed control switch to the On position.
6. Ensure that the agitation control valve is in the On
position.
7. Set the pump switch to the On position and use the
application rate switch to increase the pressure to a high
setting.
8. Set the master boom switch and boom control switches
to the On positions to begin spraying.
9. Allow all of the water in the tank to spray out though
the nozzles.
10. Check the nozzles to ensure that they are all spraying
correctly.
11. Set the master boom switch to the Off position, set the
pump switch to the Off position, and stop the engine.
12. Repeat steps 3 through 11 at least 2 more times to
ensure that the spray system is fully cleaned.
13. Clean the strainer; refer to Cleaning the Suction
Strainer, page 39.
Important
If you used wetable powder chemicals,
clean the strainer after each tank.
14. Using a garden hose, spray off the outside of the sprayer
with clean water.
15. Remove the nozzles and clean them by hand. Replace
damaged or worn nozzles.
25