Table of Contents
Advertisement
Î Î Î Î
1
Figure 39
1. Air cleaner cover
2. Gently slide filter out of air cleaner body to reduce the
amount of dust dislodged. Avoid knocking filter against
air cleaner body.
3. Inspect filter and discard if damaged. Do not wash or
reuse a damaged filter. Clean the filter as follows:
• Blow compressed air from inside to the outside of dry
filter element. Do not exceed 100 psi to prevent damage
to the element.
• Keep air hose nozzle at least 2" from filter and move
nozzle up and down while rotating the filter element.
Inspect for holes and tears by looking through the filter
toward a bright light.
4. Inspect new filter for shipping damage. Check sealing
end of filter. Do not install a damaged filter.
5. Insert new filter properly into air cleaner body. Make
sure filter is sealed properly by applying pressure to
outer rim of filter when installing. Do not press on
flexible center of filter.
6. Reinstall cover and secure latch. Make sure cover is
positioned with TOP side up.
Changing Engine Oil And Filter
Change oil and filter initially after the first 50 hours of
operation, thereafter, change oil and filter every 100 hours.
1. Raise bed (if so equipped) and place safety support on
extended lift cylinder to hold up bed.
2. Remove drain plug and let oil flow into drain pan.
When oil stops, install drain plug.
2
2. Filter
46
1
Figure 40
1. Engine oil drain plug
3. Remove oil filter. Apply a light coat of clean oil to the
new filter seal before screwing it on. Screw filter on
until gasket contacts mounting plate, then tighten 1/2 to
2/3 of a turn. DO NOT OVER–TIGHTEN.
Figure 41
1. Engine oil filter
4. Add oil to crankcase, refer to Check Engine Oil.
Fuel System
Fuel Lines and Connections
Check lines and connections every 600 hours or yearly,
whichever comes first. Inspect for deterioration, damage, or
loose connections.
Fuel Filters
Replace filter canisters after every 600 hours of operation.
1. Raise bed (if so equipped) and place safety support on
extended lift cylinder to hold up bed.
2. Place a clean container under fuel filters.
3. Loosen R–clamps securing filters to frame.
1
Advertisement
Table of Contents
