Adjusting Accelerator Pedal; Changing Transaxle / Hydraulic Fluid - Toro 07211 Operator's Manual

2. To adjust belt tension:
• Loosen idler pulley mounting nut, move pulley to
increase tension and tighten nut.
Figure 48
1. Fan belt

Adjusting Accelerator Pedal

1. Position vehicle on level surface, stop engine and
engage the parking brake.
2. Adjust ball joint on accelerator cable (Fig. 49) to allow
.200"–.350" of clearance between accelerator pedal arm
and top of diamond tread floor plate, when a 20 lb.
force is applied to center of pedal. Tighten locknut.
Note: Engine must not be running and return spring must
be attached.
Warning
Governor is preset at the factory to a maximum
engine speed of 3650 rpm. If speed is not correct,
contact your authorized Toro Dealer/Distributor.
1
2
2. Idler pulley
1
1. Accelerator cable
.200–.350" clearance
Changing Transaxle / Hydraulic
Fluid
Change Transaxle hydraulic fluid, filter and clean strainer
every 800 hours.
1. Position the vehicle on a level surface, stop engine,
engage the parking brake and remove key from ignition
switch.
2. Remove drain plug from side of reservoir and let
hydraulic fluid flow into drain pan. Reinstall and
tighten plug when hydraulic fluid stops draining.
49
2
Figure 49
2. Ball joint
Figure 50