HP ProOne 400 Maintenance And Service Manual page 77

Table 5-3 Computer Setup—Advanced (for advanced users) (continued)
Option Heading
Lets you delete any previously loaded custom boot keys. Clearing keys will disable secure boot. Default is
disabled.
Reset Secure Boot keys to factory defaults
Default is disabled.
Enable MS UEFI CA key
Disabling this setting alters the Secure Boot key list to further restrict the allowed software
components. Set this option to 'disable' to support Device Guard.
Ready BIOS for Device Guard Use
Requires BIOS Administrator password to be configured and Secure Boot to be enabled.
System Options Configure storage controller for Intel Optane
Enables the Intel Optane memory module.
Turbo boost
Intel Turbo Boost Technology (TBT) automatically allows processor cores to run faster than the base
operating frequency if it is operating below power, current, and temperature specification limits. Default
is enabled.
Multi-processor
Use this option to disable multi-processor support under the operating system. Default is enabled.
Virtualization Technology (VTx) (Intel only)
Controls the virtualization features of the processor. Changing this setting requires turning the computer
off and then back on. Default is disabled.
Virtualization Technology for Directed I/O (VTd) (Intel only)
Controls virtualization DMA remapping features of the chipset. Changing this setting requires turning the
computer off and then back on. Default is disabled.
M.2 WLAN/BT
Lets you disable the wireless module slot. Default is enabled.
M.2 SSD
Lets you disable the M.2 solid-state drive slot. Default is enabled.
Allow PCIe/PCI SERR# Interrupt (enable/disable)
Allows PCI devices to report PCI/PCIe System Error signals, such as address parity errors, data parity
errors, and critical errors other than parity. Default is enabled.
Power Button Override (disable/4 sec/15 sec)
Lets you disable or enable and select the number of seconds you have to hold down the power button for
it to force the system to power off. Default is '4 sec'.
Built-In Device Options Embedded LAN Controller
Select to show the device in the operating system. Default is enabled.
Wake On LAN
Lets you either disable the Wake On LAN feature, or configure where the computer boots, including the
network or hard drive. Default is Boot to Network.
Video Memory Size
Computer Setup (F10) Utilities 69