Whirlpool W10836808B User Instructions page 10

Start or Resume a Cycle
If needed, run hot water at the sink nearest your dishwasher
■
until the water is hot. Turn off water.
For best dishwashing results, water should be 120ºF (49ºC)
■
as it enters the dishwasher.
Select the wash cycle and options desired.
■
To repeat the same cycle and options used
previously, press START/RESUME twice.
Within 4 seconds of pressing Start/Resume
you must firmly push the door closed. If the
door is not closed within 4 seconds, the
Start button LED will flash, an audible tone
will be heard, and the cycle will not start.
NOTE: You must have successfully completed the "Connectivity Setup" section for the following features to function. Verify that the
Wireless Status icon (A) and either the Amber House icon (C) or Blue House icon (D) are illuminated. Check the Whirlpool
additional dishwasher features, including Remote Enable (B).
Download a Specialty Cycle or My Cycle
The Download & Go™ feature lets you select a Specialty Cycle
or you can design a My Cycle on the Whirlpool
to your dishwasher. When the dishwasher receives the cycle, the
Download & Go LED lights up for several minutes to indicate the
cycle has been received. When you want to use this cycle touch
DOWNLOAD & GO to select the cycle, just as you would do for
any other cycle. Press START/RESUME and close the door within
4 seconds to start the cycle.
HELPFUL TIP: The cycle will be remembered for future use until
a different cycle is downloaded to the dishwasher.
NOTE: If the Download & Go button is touched without a cycle
ready for selection, the LED will blink and you will hear an "invalid
key press" sound (if key activation sounds are turned on). When a
remote start command is received from the app, the dishwasher
will start the cycle. The Remote Enable icon (B) will remain lit.
Smart Delay
(Opt-in through Whirlpool
®
supported by your local utility)
During times of peak electrical rates (if you have opted in) you
may see the Smart Delay icon. When this occurs your dishwasher
will delay according to your opt-in choices to help alleviate peak
power demands on the local utility. The dishwasher will start up
automatically when the peak power demand has decreased. You
may override the smart delay through the app.
10
STEP 5
Dishwasher Use – Smart Operation
app and send it
®
u
app and when
You can add an item at the beginning of the cycle. Open the
■
door slowly and add the item. Press START/RESUME and
close the door firmly within 4 seconds. If the door has been
open more than 4 seconds the LED will flash, a tone will
sound and the dishwasher will not resume unless you press
Start/Resume again.
IMPORTANT: If the door has been opened after starting a cycle
(even during the Delay Hours option), Start/Resume must be
pressed again.
Set a Remote Enable
Remote Enable mode allows you to start your dishwasher
remotely from the Whirlpool
After preparing your dishwasher and selecting your cycle settings,
touch and hold the DOWNLOAD & GO button for 3 seconds. The
Remote Enable icon (B) will be solidly lit.
When a remote start command is received from the app, the
dishwasher will start the cycle. The Remote Enable icon will
remain lit.
HELPFUL TIP: Make sure that your dishwasher door remains
closed and the cycle is not changed until you start the cycle.
Opening the door after a Remote Enable has been set will cancel
the Remote Enable. If the dishwasher needs to be paused to add
dishes, the Remote Enable will need to be reinitiated.
NOTE: If no Wi-Fi connection is available, the Remote Enable
will not be set and Wireless icon (A) will blink for 2 seconds, then
go out.
q
app for
®
A
B
app.
®
C
D