Softkey Labeling - Siemens SINUMERIK 840D sl Manual

See also
Preparation for mounting (Page 19)
3.4

Softkey labeling

User-specific functions can be assigned to the horizontal and vertical softkey bars. Printed
labeling strips can be used to label the softkeys.
Blank labels are already installed on delivery.
DIN A4 films are available for making the strips (for the article number, see Chapter Overview
(Page 89)).
Note
Use the "Arial" font to format text. This font is comparable to the "Univers S57" font, used by
Siemens for the key labeling.
Procedure
1. Letter the mat side of the film using a laser printer.
2. Cut the printed labels along the preprinted lines.
3. Remove the PCU retaining screws and swing out the PCU away from the operator panel
front.
4. Insert the strips into the slots provided on the rear of the operator panel front.
5. Swing the PCU back to the operator panel and secure by tightening the screws.
If the operator panel front and PCU are dismantled, omit steps 3 and 5.
Operator panel front: OP 012
Manual, 05/2019, A5E36371591B AB
Installation
3.4 Softkey labeling
25