Chapter 3 Structure; Parts Identification - Mitsubishi Electric MELSERVO J5 Series User Manual

3
STRUCTURE
3.1

Parts identification

MR-J5-_G_
The diagram shows MR-J5-10G-RJ.
Inside of the display cover
(1)
(3)
No. Name
(1) Display section
(2) Network status LEDs
(3) Rotary switches (SW1/SW2)
(4) DIP switch (SW3)
(5) Ethernet cable connector (CN1A)
(6) Ethernet cable connector (CN1B)
(7) USB communication connector (CN5)
(8) Analog monitor connector (CN6)
(9) Functional safety I/O signal connector
(CN8)
3 STRUCTURE
36
3.1 Parts identification
RUN
MS (2)
ERR
NS
SFTY
(14)
(4)
(20)
Side
(15)
(16)
(17)
Application
The 3-digit, 7-segment LED display shows the servo status and
alarm number.
Displays each network status.
Set the IP address of the servo amplifier.
To change the mode to the test operation mode, set the switch.
(SW3-1)
Connect the controller, servo amplifier or each network connected
device.
Connect with a personal computer.
Outputs the analog monitor.
Connect an external safety relay to use the STO function. When
using other safety-sub functions, refer to "FUNCTIONAL SAFETY"
in the following manual.
MR-J5 User's Manual (Function)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(18) (19)
Bottom
Detailed explanation
Page 40 Switch setting and
display of the servo amplifier
Page 44 CN1A/CN1B
connector LED

Refer to "Connectors and pin
assignments" in the following
manual.
MR-J5 User's Manual
(Hardware)
Refer to "USING STO
FUNCTION" and "USING
FUNCTIONAL SAFETY" in the
following manual.
MR-J5 User's Manual
(Hardware)