Connection Settings; Create Device - Philips dynalite DDRC-GRMS-E Commissioning Manual

Signify Classified - Internal
2.5

Connection Settings

For configuration purposes, you can connect System Builder to the controller via UDP Multicast
(Ethernet) or Serial Connection (DyNet RS-485).
Refer to the SB Quick Start Guide or SB training Guide for more information.
2.6

Create Device

The Create Device page is only required if pre-commissioning devices. It enables offline creation
of devices on the spur connected to the DDRC-GRMS-E, such as load controllers, user interfaces
and sensors.
Refer to the SB Quickstart Guide or SB training Guide for more information.
March 5, 2019
DDRC-GRMS-E
.......................................
Commissioning Guide
.......................................
Page 15
.......................................
www.lighting.philips.com/dynalite