Operation; Switch-On; Switch-Off; Setting Standby Mode - Bosch DCU 130 Operating Instructions Manual

5.

Operation

5.1

Switch-on

!
To avoid the formation of condensation, allow the
DCU 130 to adjust to ambient temperature before
switching on the DCU 130.
1. Switch on the DCU 130 with the
seconds.
i
The start screen is always displayed after switch-on.
The applications displayed can be selected on the
start screen.
2. Touch the required application with the pen.
CAUTION – risk of injury due to triggering
of the airbag with an engaged DCU 130!
Injuries due to unintentional triggering of the
airbag when attaching (e.g. engaging) the
DCU 130 to the steering wheel.
¶
Do not secure the DCU 130 to the steering
wheel.
5.2

Switch-off

¶
Press the key for 2 - 4 seconds to prevent
DCU 130 from unintentionally switching off.
Weitergabe sowie Vervielfältigung der Zeich- Rz 10
nungen sind nicht gestattet und müssen
streng vertraulich behandelt werden. Alle ( )
Rechte sind bei ads-tec GmbH nach DIN 34.  Windows is shutting down Druckdatum/ print date: 17.12.2010
strictly confidential according to DIN 34. File:Airbag Lenkrad + TT13 Doku 130
"
DCU 130 switches off.
i
Pressing the
switch off DCU 130 without shutting down Windows
beforehand.
5.3

Setting standby mode

The standby mode parameters (e.g. the monitor
or hard disk switch-off time) can be specified in the
"Start » Control panel » Energy options" menu.
Robert Bosch GmbH
key more than 2
button for more than 4 seconds will
Operation | DCU 130 | 25
5.4

Power supply

The DCU 130 can be powered from the following:
R
Battery
R
Power supply unit
!
Always use the power supply unit included in the
scope of delivery!
5.5

Battery operation

The DCU 130 has two batteries as an alternative source
of power for the DCU 130.
i
It is possible to change one battery during operation.
The power supply unit must be connected if both
batteries are to be replaced.
i
The batteries are charged automatically during mains
operation.
The two fully charged batteries of the DCU 130 are
designed as back-up batteries to guarantee approx.
3 hours of independent operation.
i
A warning window appears if the battery charge is
less than 15 %. The power supply unit is then to be
connected to enable the batteries to be re-charged.
i
The battery charge can be determined at any time
using the "Battery Information and Diagnosis Tool.
Further information can be found in Section 6.1.1.
5.6

Touch screen with pen

The touch screen of the DCU 130 is operated with a
pen which basically has the same functions as a mouse.
R
A single click with the left mouse key corresponds to
a single touch of the pen on an icon for example, or
positioning of the cursor on an input box.
R
A double click with the left mouse key corresponds
to touching the touch screen twice with the pen.
This is used to start an application program for
example.
i
For notes on touch screen calibration refer to Sec-
tion 6.2.
en
|
1 689 989 091 2014-05-14