Replacement Of Discharge Air Hose And Exhaust Air Hose - Panasonic NA-D106X1 Service Manual

NA-D106X1
*Points to note when assembling the Sensor U (TH1,
TH2)
Insert the Sensor U (TH1, TH2) into the hole in the narrow
pitch area as shown in the figure below. Then, fit the cord
seal rubber onto the Sensor U as if to insert it into the
hole.
Important Notice
*Set the Dry filter as shown in the figure and perform the
Service check D (mode d1).
8.14.3. Replacement of Discharge air hose
and Exhaust air hose
1. When the Heater cover block is pulled out in the
procedure 6 of Replacement of Fan case U (8.6.1),
loosen the Sub hose clamp, and then replace the
Discharge air hose and Exhaust air hose.
44