Sanyo A5514SA Operating Instructions Manual page 30

Acknowledging Special Precautions and the FCC notice
FCC Notice
The phone may cause TV or radio interference if used in close proximity
to receiving equipment. The FCC can require you to stop using the
phone if such interference cannot be eliminated.
Vehicles using liquefied petroleum gas(such as propane or butane)
must comply with the National Fire Protection Standard (NFPA-58). For
a copy of this standard, contact the National Fire Protection Associa-
tion, One Batterymarch Park, Quincy, MA02269, Attn: Publication Sales
Division.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Cautions
Any changes or modifications to your phone not expressly approved in
this document could void your warranty for this equipment and void your
authority to operate this equipment. Only use approved batteries, anten-
nas and chargers. The use of any unauthorized accessories may be dan-
gerous and voids the phone warranty if said accessories cause damage
or a defect to the phone.
Although your phone is quite sturdy, it is a complex piece of equipment
and can be broken. Avoid dropping, hitting, bending or sitting on it.
Body-worn Operation
To maintain compliance with FCC RF exposure requirements, Body-worn
operations are restricted to designated optional holster of A5514SA or
to belt-clips, holsters or similar accessories that have no metallic com-
ponent in the assembly and that provide at least 1.5cm separation
between the device and the user's body. Use of non-recommended
accessories may violate FCC RF exposure requirements.
57
For more information about RF exposure, please visit the FCC website at
www.fcc.gov.
Specific Absorption Rate (SAR) for Wireless Phones
The SAR is a value that corresponds to the relative amount of RF energy
absorbed in the head of a user of a wireless handset. The SAR value of
a phone is the result of an extensive testing, measuring and calculation
process. It does not represent how much RF the phone emits. All phone
models are tested at their highest value in strict laboratory settings.
But when in operation the SAR of a phone can be substantially less that
the level reported to the FCC. This is because of a variety of factors
including its proximity to a base station antenna, phone design and
other factors. What is important to remember is that each phone meets
strict federal guidelines. Variations in SARs do not represent a variation
in safety.
All phones must meet the federal standard, which incorporates a sub-
stantial margin of safety. As stated above, variations in SAR values
between different model phones do not mean variations in safety. SAR
values at or below the federal standard of 1.6 W/kg are considered safe
for use by the public.
The highest reported SAR values A5514SA are:
CDMA modes(Part 22)- Head: 0.359 W/kg; Body-worn: 0.528 W/kg
FCC Radio Frequency Emission
This phone meets the FCC Radio Frequency Emission Guidelines. FCC
ID number: NRNA5514SA. More information on the phone's SAR can be
found from the following FCC website: http://www.fcc.gov/oet/fccid.
58