Install The Display Unit - Sony SU-P50T2 Instructions Manual

Install the Display Unit

WARNING
Be sure to complete the installation before connecting the mains lead to the wall socket. If you allow the mains
lead to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock.
If you stumble over the mains lead or the Display Unit, the stand may topple over and cause injury.
1
Install the Display Unit on the Table-Top Stand.
1 Connect the mains lead and the Display Interface Cable to the Display Unit.
z Tip
See the instruction manual of the Sony
Flat Panel Colour Television for more details on
connecting the mains lead and the Display
Interface Cable.
Notes
• If the weight of the Display Unit is placed on
the speakers, deformation or a loose
connection of the speakers may result. To
avoid this, observe the following. (KE-
61MR1/KE-MR61 only)
– Do not hold the speakers when carrying
the Display Unit.
– When connecting cables to the Display
Unit, place packing material, etc. on the
floor and lay the Display Unit face down
on it so that the speakers on either side of
the Display Unit are clear of the packing
material, etc.
• Be sure to place the Display Unit stably.
• Use soft cloth to protect the screen of the
Display Unit from damage or dirt.
Illustrations without model names that appear from now on are based on the Flat Panel colour television KE-MR50.
Rear side of the Display Unit
Soft rag
KE-50MR1/KE-MR50
Speaker (left)
Soft rag Speaker (right)
KE-61MR1/KE-MR61
Mains lead
Display
Interface Cable
Rear side of the
Display Unit
Packing material,
etc.
7
(GB)