Installer Setting Code Table - LG 457938 Owner's Manual

Installation Instruction
Installer Setting - Installer Setting Code Table
0 Mode Override
Ceiling Height
1
Selection
Group Control
2
Auxiliary heater
This Function is only for Non-Auto Changeover H/P model.
Indoor unit connected to wired remote controller operate as wired remote controller setting.
This function is only for group control. Please donʼt set this function in case of non-group control.
After setting Group Control of the product, turn off the power then turn it back on after 1 minute.
This function is only applied to models with Auxiliary Heater function being activated.
10 Wireless Remote Controller
0 : Set to Master
0
1 : Set to Slave
1 : Standard
2 : Low
1
3 : High
4 : Super High
0 : Set to Master
2 2
1 : Set to Slave
2 : Check Master/Slave
3 : Set to Auxiliary heater
2 2
4 : Cancel Auxiliary heater
5 : Check Auxiliary heater Installation