Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZGH96524XS
Summary of Contents for Zanussi ZGH96524XS
- Page 1 User Manual GETTING STARTED? EASY. ZGH96524XS EN User Manual...
-
Page 2: Safety Information
VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. - Page 3 WARNING: Unattended cooking on a hob with fat or oil can be • dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the • appliance and then cover flame e.g. with a lid or a fire blanket. WARNING: The appliance must not be supplied through an •...
-
Page 4: Safety Instructions
SAFETY INSTRUCTIONS plug (if applicable) can make the terminal This appliance is suitable for the following markets: become too hot. • Use the correct electricity mains cable. • Do not let the electricity mains cable tangle. • Make sure that a shock protection is installed. INSTALLATION •... - Page 5 Make sure to connect the appliance according • Do not use large cookware that overlap the to current installation regulations. Follow the edges of the appliance. This can cause damage requirements for adequate ventilation. to the worktop surface. • Make sure the flame does not go out when you quickly turn the knob from the maximum to the minimum position.
-
Page 6: Installation
• Disconnect the appliance from the mains • Flat the external gas pipes. supply. • Cut off the mains electrical cable close to the appliance and dispose of it. INSTALLATION B. Washer supplied with the appliance WARNING! Refer to Safety chapters. C. -
Page 7: Adjustment Of Minimum Level
this label in the package supplied with the appliance. If the supply gas pressure is changeable or different from the necessary pressure, you must fit an applicable pressure adjuster on the gas supply pipe. ADJUSTMENT OF MINIMUM LEVEL To adjust the minimum level of the burners: 1. - Page 8 CONNECTION CABLE To replace the connection cable use only the special cable or its equivalent. The cable type is: H03V2V2-F T90. Make sure that the cable section is applicable to the voltage and the working temperature. The yellow / green earth wire must be approximately 2 cm longer than the brown (or black) phase wire.
-
Page 9: Product Description
Kitchen unit with door 40 mm 30 mm min 6 mm 20 mm min 30 mm min 5 mm (max 150 mm) 60 mm A. Removable panel B. Space for connections Kitchen unit with oven The electrical connection of the hob and the oven CAUTION! Install the appliance only must be installed separately for safety reasons and on a worktop with flat surface. -
Page 10: Daily Use
CONTROL KNOB Symbol Description Symbol Description minimum gas supply no gas supply / off position ignition position / maximum gas supply DAILY USE C. Ignition candle WARNING! Refer to Safety chapters. D. Thermocouple IGNITION OF THE BURNER BURNER OVERVIEW Always light the burner before you put on the cookware. -
Page 11: Turning The Burner Off
CAUTION! In the absence of The hob is supplied with the electricity you can ignite the burner progressive valves. They make the without electrical device; in this case flame regulation more precise. approach the burner with a flame, turn the control knob counter-clockwise to TURNING THE BURNER OFF maximum gas supply position and To put the flame out, turn the knob to the off... -
Page 12: Care And Cleaning
CARE AND CLEANING WARNING! Refer to Safety chapters. GENERAL INFORMATION • Clean the hob after each use. • Always use cookware with a clean base. • Scratches or dark stains on the surface have no effect on how the hob operates. •... -
Page 13: Troubleshooting
TROUBLESHOOTING WARNING! Refer to Safety chapters. WHAT TO DO IF... Problem Possible cause Remedy There is no spark when you try The hob is not connected to an Check if the hob is correctly to activate the spark generator. electrical supply or it is con- connected to the electrical nected incorrectly. -
Page 14: Technical Data
LABELS SUPPLIED WITH THE ACCESSORIES BAG Stick the adhesive labels as indicated below: MOD. MOD. MOD. TYPE PROD.NO. IP20 PROD.NO. PROD.NO. SER.NO. 0049 SER.NO SER.NO 03 IT DATA DATA MADE IN ITALY A. Stick it on Guarantee Card and send this part C. -
Page 15: Environmental Concerns
OTHER TECHNICAL DATA Gas original: G20 (2H) 20 mbar 11,65 kW TOTAL POWER: Gas replace- G30 (3+) 28-30 mbar 825 g/h ment: G31 (3+) 37 mbar 811 g/h Electric supply: 220-240 V ~ 50-60 Hz Appliance cate- II2H3+ gory: Gas connection: R 1/2"... - Page 16 WWW.ZANUSSI.COM/SHOP...