Children of less than 3 years should be kept away unless • continuously supervised. General Safety The appliance and its accessible parts become hot during use. • Do not touch the heating elements. Do not operate the appliance by means of an external timer or • separate remote-control system. www.zanussi.com...
• All electrical connections should be made by • Seal the cut surfaces with a sealant to a qualified electrician. prevent moisture to cause swelling. • The appliance must be earthed. • Protect the bottom of the appliance from steam and moisture. www.zanussi.com...
Page 4
• Before installation, make sure that the local WARNING! distribution conditions (nature of the gas and Risk of damage to the appliance. gas pressure) and the adjustment of the • Do not keep hot cookware on the control appliance are compatible. panel. www.zanussi.com...
• Do not let acid liquids, for example vinegar, • Use original spare parts only. lemon juice or limescale remover, touch the hob. This can cause matt patches. Product description Cooking surface layout Auxiliary burner Rapid burner Semi-rapid burner Control knobs Button for the spark generator www.zanussi.com...
If the burner accidentally goes out, fire in the kitchen environment. The turn the control knob to the off manufacturer declines any position and try to light the burner responsibility in case of the flame again after minimum 1 minute. misuse. www.zanussi.com...
• Scratches or dark stains on the surface have no effect on how the hob operates. • Use a special cleaner applicable for the surface of the hob. • Wash stainless steel parts with water, and then dry them with a soft cloth. www.zanussi.com...
10 seconds The flame ring is uneven. Burner crown is blocked with Make sure that the injector is not food residues. blocked and the burner crown is clean. www.zanussi.com...
Gas Safety (Installation and Use) m³ and 10 m³ an air vent of effective area of 50 Regulations (Current Edition) and the IEE cm² is required, while if the volume exceeds 11 Wiring Regulations (Current Edition). m³ no air vent is required. www.zanussi.com...
Page 10
Carry out connection by using metal rigid pipes (copper with mechanical end). Injectors replacement 1. Remove the pan supports. 2. Remove the caps and crowns of the burner. 3. With a socket spanner 7 remove the injectors and replace them with the ones www.zanussi.com...
Page 11
There is a risk of fire. • Do not let the power cable to heat up to a temperature of more than 90° C. The cable should be guided by means of clamps fixed to the side of the cabinet, in order to avoid www.zanussi.com...
Page 12
100 mm min. 650 mm The replacement of electric cable min. 55 mm must be carried out exclusively by 30 mm the service force centre or by 550 mm personnel with similar competencies, in accordance with the current regulations. www.zanussi.com...
Return the product to your the packaging in applicable containers to local recycling facility or contact your municipal recycle it. Help protect the environment and office. human health and to recycle waste of electrical and electronic appliances. Do not dispose www.zanussi.com...