Table of Contents
Advertisement
MAINTENANCE PROCEDURE
METHOD FOR CHECKING SWING PARKING BRAKE
For checking the swing parking brake, ask your Komatsu distributor to perform the work.
CHECKS BEFORE STARTING
For the following items, see OPERATION, "METHOD FOR CHECKING BEFORE STARTING".
•
Method for draining water and sediment from fuel tank
•
Method for checking water separator, draining water and sediment
•
Method for checking oil level in hydraulic tank, adding oil
•
Method for checking coolant level, adding coolant
•
Method for checking oil level in engine oil pan, adding oil
•
Method for checking electric wiring
•
Method for checking fuel level, adding fuel
•
Method for checking DEF level, adding DEF
•
Method for checking working lamp
•
Method for checking horn function
•
Method for checking capacitor
EVERY 100 HOURS MAINTENANCE
METHOD FOR LUBRICATING WORK EQUIPMENT
NOTICE
If any abnormal noise is generated from any greasing point, perform greasing regardless of the greas-
ing interval.
Perform greasing every 10 hours for the first 50 hours operation on a new machine.
After the machine is subjected to digging work in the water, be sure to grease the wet pins.
Items to be prepared
Grease pump
1.
Park the machine on a level and firm ground, lower the
work equipment to the ground in the posture shown in the
figure, and stop the engine.
2.
By using a grease pump, pump in grease through the grease fittings shown by arrows.
(1) Arm-Link connection pin (1 place)
(2) Arm-Bucket connection pin (1 place)
4-44
MAINTENANCE
Advertisement
Table of Contents
