Fujitsu 420D User Manual page 115

Problem
Your notebook turns o all by itself.
T r o u b l e s h o o t i n g
Possible Cause
1. The Power Savings parameters are set for
auto timeouts which are too short for your
operating style.
2 . You are opera ting on b a t tery on ly and have
i gn ored a low battery alarm until the battery
is at the de ad battery state and your noteboo k
has gone into De ad Ba t tery Su s pend Mode.
3. You have a failure of the Battery.
4. The Power Adapter has failed or lost it's
power source.
L i f e B o o k 4 0 0 S e r i e s f r o m F u j i t s u
Possible Solution
1. Use the keyboard or pointer and if that does
not restore operation,push the Resume Button.
You may want to close the application and Go
to the Setup Utility Power Savings Menu and
adjust the timeout values to better suit your
operation. (See the Power Savings Menu on
pages 67-69, and Power Center by Fujitsu on page
20.)
2. Install a Power Adapter and then push
the Resume Button. (See Low Battery State
on page 26.)
3. Verify the condition of the battery using the
Status Indicator, (Figure 2-3 on page 17),and
replace or remove it if it is shorted.
4. Make sure the adapter is plugged in and the
outlet has power.
95