Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
WARNING
If you leave the key in the switch, someone could accidentally start the engine and seriously
injure you or other bystanders.
Remove the key from the switch before you install the cutting unit
DANGER
If the engine is started and the PTO shaft is
allowed to rotate, serious injury could result.
Do not start the engine and engage the PTO
switch when the PTO shaft is not connected
to the gearbox on the cutting unit.
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
Description
No parts required
No parts required
Debris guard
Bracket
Rivet
Hex-head bolt
Washer
Height-of-cut pin
Shoulder bolt
Spacer
No parts required
No parts required
Qty.
–
Prepare the machine.
–
Install the CE kit (if required).
1
1
Install the debris guard to the front axle.
5
2
2
Install the cutting unit to the traction unit.
2
2
Install the PTO cover.
2
–
Level the cutting unit.
–
Grease the cutting unit.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
2
Installing the CE Kit
If Required (CE-Compliant
Countries Only)
No Parts Required
Procedure
If you use this machine in a country that complies
to CE standards, install the CE Kit; refer to the kit
Installation Instructions.
8
Use
Advertisement
Table of Contents
