Removing The Cutting Unit From The Traction Unit - Toro Groundsmaster 3200 Series Operator's Manual

Figure 18
1. Gearbox
2. Bolts and nuts
Removing the Cutting Unit
from the Traction Unit
1. Park the machine on a level surface with the
cutting unit raised.
2. Remove the height-of-cut pins
the cutting-unit side plates.
Figure 19
1. Height-of-cut chain
3. Lower the cutting unit, engage the parking
brake, shut off the engine, and remove the key.
4. Remove the bolts and washers that secure the
lift arms to the castor arms.
g299646
3. PTO driveshaft
(Figure 19) from
g296784
2. Pin
1. Lift arm
2. Castor arm
5. Remove the bolts and nuts from the PTO shaft
(Figure 21) and slide the yoke out of the gearbox.
Note:
Refer to the Operator's Manual, to
properly align the splines if you separate the
drive shaft components.
1. Gearbox
2. PTO shaft
18
Figure 20
3. Washer
4. Bolt
Figure 21
3. Bolts and nuts
g296375
g299646