Figure 17
1. Gearbox
2. Bolts and nuts
Removing the Cutting Unit
from the Traction Unit
1.
Park the machine on a level surface with the
cutting unit raised.
2.
Remove the height-of-cut pins
the cutting-unit side plates.
Figure 18
1. Height-of-cut chain
3.
Lower the cutting unit, engage the parking
brake, shut off the engine, and remove the key.
4.
Remove the bolts and washers that secure the
lift arms to the castor arms.
g299646
3. PTO driveshaft
(Figure
18) from
g296784
2. Pin
1. Lift arm
2. Castor arm
5.
Remove the bolts and nuts from the PTO shaft
(Figure
20) and slide the yoke out of the gearbox.
1. Gearbox
2. PTO shaft
DANGER
If the engine is started and the PTO shaft
is allowed to rotate, serious injury could
result.
Do not start the engine and engage the
PTO lever when the PTO shaft is not
connected to the gearbox on the cutting
unit.
17
Figure 19
3. Washer
4. Bolt
Figure 20
3. Bolts and nuts
g296375
g299646