Port Replicator - Fujitsu Point 1600 User Manual

Port Replicator

Peripheral connectors on the port replicator are described in Table 2-2.
Port
Serial Port A
Serial Port B
Parallel Port
Floppy Disk
Drive Port
Mouse Port
Video Port
DC Input
Keyboard Port
Note: The ability of the pen tablet to utilize these ports is determined by BIOS
configuration settings. Contact your local help desk or reseller if you suspect that
your pen tablet's BIOS settings are preventing peripheral devices from working
properly.
2-6 Using Point 510/Point 1600 Connectivity Peripherals
Table 2-2. Port Replicator Peripheral Connectors
This connector can be used to connect an external
device with a serial interface such as a modem. This
is a fully-functional RS232-C serial port.
This connector can be used to connect an external
device with a serial interface. Note the following:
1) This port provides only the Rx and Tx (receive and
transmit) signals of the RS232-C interface.
2) When this port is enabled, the IrDA port on the pen
tablet is disabled.
This connector can be used to connect a device with
a parallel interface such as a parallel printer.
This connector can be used to connect the Fujitsu
FMWFD2 floppy disk drive.
This connector can be used to connect a PS/2-style
mouse.
This connector allows you to connect an external
SVGA monitor. Note that an external monitor and the
pen tablet display screen can be viewed
simultaneously with the Point 1600 pen tablet, but not
with the Point 510.
This connector can be used to connect the Point 510/
Point 1600 AC adapter or auto adapter.
This 6-pin mini-DIN plug can be used to attach a
PS/2-style keyboard.
Description
2