Inserting The Pen Tablet - Fujitsu Point 1600 User Manual

Inserting the Pen Tablet

To insert the pen tablet into the port replicator,
1. Suspend or shut down and turn off the pen tablet.
Note that driver software for the peripheral device you intend to use with the
pen tablet system may need to be initialized upon starting the system. If this is
the case, you may need to shut down the system rather than suspend system
operation. Contact your local help desk or reseller for details on using specific
peripheral devices with your system.
2. Turn off the devices you intend to connect to the port replicator.
3. Turn off any peripheral devices that are already connected to the port replicator.
4. If you are attaching peripheral devices to the port replicator, do so now. Insert
the connectors of the devices into the appropriate ports on the bottom of the
port replicator. Tighten the connector screws, if used, to maintain consistent and
reliable connections between the devices and the port replicator. The following
illustration shows the locations of peripheral connectors on the port replicator.
Mouse Port
Keyboard Port
5. If using a locking-style port replicator, ensure that the cradle latches inside the
port replicator are in the unlocked position. (See "Synchronizing Cradle
Latches" at the end of this chapter for a description of how the cradle latches in
the port replicator work.)
DC Input Serial Port B
Serial Port A
Figure 2-2. Port Replicator, Bottom View
Mouse Port
Floppy Disk
Drive Port
Parallel Port
Video Port
Port Replicator
2
2-7