Fujitsu ScanSnap S300 Getting Started Manual page 20

• Be sure to use the supplied AC adapter and AC cable.
ATTENTION
• Be sure to use the supplied USB cable.
• If only the USB cable is used, the ScanSnap does not operate. Be
• When connecting to a USB hub, be sure to use the first stage USB
• When connecting with a USB 2.0 cable, make sure that the USB port
When connecting with the USB bus power cable:
•
Use the USB bus power cable
1. Connect the USB bus power cable.
Remove the adhesive label covering the USB and Power connectors
Connect to the ScanSnap's Power connector and a personal computer.
2. Connect the USB cable.
Connect the USB cable to both the ScanSnap and personal computer.
USB connector
3. After power and USB ports are connected with cables, perform the
procedure described in "Turning the ScanSnap ON" (page 20).
19
The operation with any commercially available USB cable is not
guaranteed.
sure to use two types of cables, Power and USB cables, to connect
the ScanSnap to a personal computer.
hub that is closest to the computer. If you use the second or later hub
stages, the scanner may not operate properly.
to connect to and hub must be USB 2.0-compliant. Note that if
connected with a USB 1.1 cable, the scanning speed may become
slow. When a USB 2.0-compliant port is available, it is recommended
that the USB 2.0-compliant port be used.
and USB cable
Power connector
PC
.
USB port