Procedure To Operate Without Installing Configuration Tool - Mitsubishi Electric MELSEC iQ-R Series User Manual

MELSEC iQ-R High Speed Data Communication Module Programming Manual

Procedure to operate without installing Configuration Tool

This section shows the procedure for using a high speed data communication module without installing Configuration Tool.
: No operation required
Step High speed data
communication module
1 Mount a high speed data
communication module on the base
*2
unit.
2 Connect the high speed data communication module to a configuration personal
computer on a 1:1 basis. (Page 55 System configuration for the initial setup,
maintenance, and inspection)
3 Turn the power of a CPU module ON.
(The high speed data communication
module's RUN LED turns ON.)
4 Insert an SD memory card in the high
speed data communication module.
(Page 50 SD Memory Card)
5 
6
7
8
9
10
11 Turn the power of the CPU module
OFF.
12 Connect the high speed data communication module, configuration personal computer, and development personal
computer to the network according to the network settings set in Configuration Tool.
13 Turn the power of the CPU module
ON.
14 Check the operation.

15
16
17
*1 Perform the self-diagnostic test as necessary. (MELSEC iQ-R High Speed Data Communication Module User's Manual
(Application))
*2 Do not use an electric screwdriver to attach and remove module fixing screws.
*3 For the operation methods of Configuration Tool, refer to the following:
MELSEC iQ-R High Speed Data Communication Module User's Manual (Application)
*4 For details on the user program, refer to the following:
MELSEC iQ-R High Speed Data Communication Module Programming Manual
4 PROCEDURES BEFORE OPERATION
36
4.1 Startup of High Speed Data Communication Module
Configuration personal
*1
computer

Configure the web browser. (Page
39 Configuring the web browser)
Connect to the high speed data
communication module with the web
browser. (Page 44 Connecting
with a web browser)
Start Configuration Tool. (Page 45
Starting Configuration Tool)
Select "Direct connection" in the
"Transfer setup" screen.
Format the SD memory card as
*3
necessary.
Set the common setting.
*3
Set the label setting.
Write the settings to the high speed
data communication module.



Development personal
computer

*3
*3
Copy High Speed Data
Communication Library.
Create a user program.

*3


Copy a user program execution
file to a host computer.

Host computer

*4
*4
Connect a host computer to the
high speed data communication
module.

Execute the user program.
*4