Bosch CL400 Manual page 52

6- -4 R5CON
P4
Parameter Attribute
P4 W
In case of an error, i.e. high byte of P3 = 03
cated in P4. In general, the evaluation of this code is only required during
commissioning or in case of service.
The error message is available for one PLC cycle only.
Detailed error descriptions are available:
D for BUEP03E and BUEP64 in the R500 manual, order no. 1070 072 131
D for BUEP-E and BUEP19E in chapter 7.3.3
Description
Error message
, the detailed error code is lo-
H
1070 072 196-101 (00.06) GB