Measurements; Viewing Measurements - ABB COM600 Series Operator's Manual

COM605 3.1
3.11.
3.11.1.
28
COM600 Station Automation Series
Operator's Guide
the parameter changes are only saved temporarily, and they will be lost after next
reset of the IED.
When writing parameters to REF 542plus:
• Parameter value changes are not activated immediately
when you click Write to IED, but only after you have
stored the values permanently by clicking OK or tempor-
arily by clicking Cancel in the store dialog. The store
dialog appears when you click Disable Write or when
you close the parameter setting tool while a write session
is open.
• Parameter Set selection will restore the old value until
the new value has been stored permanently or temporarily.

Measurements

Viewing measurements

To view measurement information, click on Measurements below the desired IED in
the substation structure. HMI updates the measurement information automatically.
Figure 3.11.1-1 An example view of measurements
1MRS756121
measurements.png